GUZZI CARDELLINO
Title
Go to content
Also started on the inlet, but this went all wrong.
When I had it ready it turns out the cab fits, but the throthlecable won't so I will need to design it better (think with an angular towards the right side)
Roughly looking if it could fit.
I should have picked this option, with an angle to the right.
Well her i go, outside diameter
Internal diameter
Small angular, for welding it later
Mounting plate
Now with mounting holes.
Welded.
Making it smooth
Getting better
Smooth out internal diameter
The cutting lines
Roughly
Smoothing it out.
Flatten it.
18mm one side
16,8mm other side
Reverse tapper.
Ready
Inlet mounted
Found out it won't fit as thought.
Will need to start all over again.
Back to content